Yamaha MBK XMAX 2014, Service Manual

Page: 236 / 482

ENGINE REMOVAL
5-5
EAS23720
INSTALLING THE ENGINE
1. Install:
• Engine “1”
• Engine bracket “2”
• Engine bracket rods “3”
• Spacer “4”
• Engine mounting nut/washer/bolt “5”
• Engine bracket rod bolts/washers/nuts “6”
• Engine bracket nuts/bolts “7”
• Rear shock absorber assemblies “8”
TIP
• Do not fully tighten the bolts and nuts.
• Be sure to install each engine bracket rod “3”
with the white mark “a” on the rod facing for-
ward.
2. Tighten:
• Engine bracket rod nuts “6”
• Engine mounting nut “5”
• Engine bracket nuts “7”
3. Tighten:
• Rear shock absorber assembly upper nuts
• Rear shock absorber assembly lower bolts
4. Install:
• Gasket
• Exhaust pipe
• Exhaust pipe nuts
(temporarily tighten)
5. Install:
• Muffler
• Muffler mounting bolts
(temporarily tighten)
TIP
Install the muffler mounting bolts in the proper in-
stalling sequence as shown.
6. Tighten:
• Muffler mounting bolts
T
R
.
.
Engine bracket rod nut
64 Nm (6.4 m·kgf, 46 ft·lbf)
Engine mounting nut
43 Nm (4.3 m·kgf, 31 ft·lbf)
Engine bracket nut
59 Nm (5.9 m·kgf, 43 ft·lbf)
3
a
T
R
.
.
Rear shock absorber assembly
upper nut
32 Nm (3.2 m·kgf, 23 ft·lbf)
Rear shock absorber assembly
lower bolt
29 Nm (2.9 m·kgf, 21 ft·lbf)
T
R
.
.
Muffler mounting bolt
53 Nm (5.3 m·kgf, 38 ft·lbf)
7
2
6
6
7
8
1
4
5
6
7
6
3
3
5
New