LS9 Editor Owner’s Manual
35
❏
INSERT (INPUT CH 1–32 only)
A
ON
Enables/disables insert-in/out.
B
OUT (Insert out)
Click this to select the output port that will be assigned to insert-out, from the following choices.
(*)
SLOT2 can be displayed only if you’re editing offline and have selected LS9-32 in the Model Select field of the Mixer Setup window,
or if you are editing online with the LS9-32 connected.
C
IN (Insert in)
Click this to select the input port that will be assigned to insert-in, from the following choices.
(*)
SLOT2 can be displayed only if you’re editing offline and have selected LS9-32 in the Model Select field of the Mixer Setup window,
or if you are editing online with the LS9-32 connected.
D
POINT (Insert point)
Selects the position at which insert-in/out will be patched. Choose from PRE EQ or PRE FADER.
❏
DIRECT OUT (except for ST IN CH)
A
ON
Turns the direct output on/off.
B
DIRECT OUT GAIN
Adjusts the gain of the direct output. The current value is shown in the numerical box below the knob. You can set
this to the nominal value (0.0 dB) by holding down the <Ctrl>(<
>) key and clicking the knob.
C
DIRECT OUT PORT
Click this to select one of the following output ports as the one used for direct out.
NONE
No assignment
SLOT1-1...SLOT1-16, SLOT2-1
(*)
...SLOT2-16
(*)
Output channels of an I/O card installed in a slot
RACK1A, RACK1B...RACK5L(A)...RACK8R(B)
L/R inputs of Rack 1–8
NONE
No assignment
SLOT1-1...SLOT1-16, SLOT2-1
(*)
...SLOT2-16
(*)
Input channels of an I/O card installed in a slot
RACK1A, RACK1B...RACK5L(A)...RACK8R(B)
L/R outputs of Rack 1–8
NONE
No assignment
OMINI1–OMNI16
(*)
OMNI jacks 1–16
(*)
SLOT1-1...SLOT1-16, SLOT2-1
(*)
...SLOT2-16
(*)
Output channels of an I/O card installed in a slot
2TR DOUT L, 2TR DOUT R
L/R channels of the 2 TR OUT DIGITAL jack
1
2
3
4
1
2
3
4
