![background image](http://html2.mh-extra.com/html/yamaha/loopfactory-an200/loopfactory-an200_manual_3217778030.webp)
30
Parameters /
AN200 Editor Main Window
• VCO 1 EDGE
Range: 0 ... 127
This determines the sharpness or smoothness of the edge of the VCO1 wave. Higher
values produce a sharper wave, resulting in a harsher sound. Lower values produce a
rounder wave, resulting in a softer sound. A value of "0" results in a sine wave.
VCO 1 PWM (Pulse Width Modulation) Parameters
• The PWM parameters are not available when
set to "Multi Saw."
• VCO 1 PWM SRC (Pulse Width Modulation Source)
Settings: Fixed, PEG, FEG, LFO 1, LFO 2,
LFO 2 Phase, LFO 2 Fast
, VCO 2
This determines the source wave which changes the VCO1's pulse width over time, thus
determining the behavior of the pulse width. When this is set to "Fixed," there is no
change in modulation over time.
• VCO 1 PWM DEPTH (Pulse Width Modulation Depth)
Range: -64 ... +63
This determines the amount of depth of the pulse width modulation of the VCO 1, based
on the PWM Source wave parameter (above). Higher (positive) values produce a deeper
modulation.