CONNECTIONS
Connecting speakers
En
19
3
Check that “SP IMP.” is displayed on the front panel.
4
Press STRAIGHT repeatedly to select a “6
Ω
MIN.”
5
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
1
Remove approximately 10 mm of insulation from the
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2
Loosen the speaker terminals.
3
Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
4
Tighten the terminal.
■
Connecting extra speakers
The EXTRA SP jacks can connect to the following speakers.
1
Press down the tab and insert the bare end of the
speaker cable into the hole in the terminal.
2
Release the tab to secure the wire.
SPIMP.-8MIN
•
Front L/R speakers
•
Center speaker
•
Surround L/R speakers
•
Surround back L/R speakers
•
Bi-amp connection (Front speaker L/R speakers)
FR
ONT
2
2
3
1
4
4
•
Presence L/R speakers
•
Zone2 speakers
EX
ZO
PR
Red: positive (+)
Black: negative (–)
