49
English
SETUP CODES
If you are using the DVD MENU position
for a second (or third) VCR, you must
preset the code for an LD player to the
DVD/LD position.
1.
Turn on the VCR to be used.
2.
Set the SELECTOR DIAL to the
CBL/DBS or DVD MENU position.
3.
Press both VOLUME buttons (
) for about four seconds at the
same time so that the indicator
flashes twice.
4.
Press MUTE.
5.
Use the numeric buttons to enter the
four-digit code for the second (or
third) VCR. Make sure that the
indicator flashes twice. If the
indicator does not flash, repeat
steps 3 and 4, and re-enter the
code.
6.
Press POWER (or any other button)
on the remote control to check if you
have preset the code correctly. If
the VCR cannot be controlled with
the remote control, try entering
another code for the same manufac-
turer.
To control your components
(MD recorder, DVD player,
TV, etc.)
1.
Turn on the component to be used.
2.
Set the SELECTOR DIAL to the
desired position for the component
(TAPE/MD, DVD/LD, TV, etc.).
3.
Press both VOLUME buttons (
) for about four seconds at the
same time so that the indicator
flashes twice.
4.
Use the numeric buttons to enter the
four-digit manufacturer’s code for
the component to be used. Make
sure that the indicator flashes twice.
If the indicator does not flash, repeat
step 3 and re-enter the code.
5.
Press POWER (or any other button)
on the remote control to check if you
have preset the code correctly. If
the component cannot be controlled
with the remote control, try entering
another code for the same manufac-
turer.
To use a second (and third) VCR
You can use the CBL/DBS and/or DVD
MENU positions to control a second
(and/or third) VCR if a CBL (or DBS) or
DVD player is not being used.
Returning to the factory-set
codes
To return all components to the factory-
set codes, follow these steps.
1.
Set the SELECTOR DIAL to a
position other than the AMP/TUN or
DSP position.
2.
Press both VOLUME buttons (
) for about four seconds at the
same time so that the indicator
flashes twice.
3.
Enter code number “9987”.
4.
Make sure that the indicator flashes
twice.
To return each component to the factory-
set code, follow these steps.
1.
Set the SELECTOR DIAL to the
position for the component to be
returned to the factory-set code.
2.
Press both VOLUME buttons (
) for about four seconds at the
same time so that the indicator
flashes twice.
3.
Enter code number “9999”.
4.
Make sure that the indicator flashes
twice.
The following codes are preset as the
factory settings.
Factory-set codes
POSITION Component Code
*1
Code
*2
TV
TV
0037
0047
CBL/DBS DBS tuner
2455
2566
VCR
VCR
3072
3060
DVD/LD
DVD player 4545 YAMAHA
CD
CD player
6187 YAMAHA
TAPE/MD Tape deck
8524 YAMAHA
*1: Australia model
*2: U.S.A., Canada and China models
We recommend that you write all the
code numbers you have preset on the
“Quick Reference Card.”
Presetting the remote control
Perform the presetting procedure for each component you want to control with the remote control.
Note: If your component does not respond to any of the codes listed for the manufacturer, use the original remote control that was
supplied with the component.
01RX-V595a-e/f6
6/24/99, 11:46 AM
49
