Yamaha FZ6-S 2004, Service Manual

Page: 68 / 456

2-42
Y Make sure to pass the neutral switch lead through
the hole of the flap.
Z Clamp the seat lock wire to the frame as shown in
the illustration. Secure the clamp to the weld of the
cross member with the frame. Position the binding
section in front of the vehicle body and cut the tip to
be between 1 and 5 mm (0.04 and 0.20 in).
S To the rear turn signal light (left)
T Pass the fuel tank drain hose through the clamp lo-
cated under the coolant reservoir tank.
U Route it behind the starter motor lead.
V Point the bend-R section of the throttle cable (pull
side) to the inner side horizontally. It is also possible
to visually check the bend-R section.
W To the headlight lead.
X Point the tip of the clamp to the inner side of the ve-
hicle body.
CABLE ROUTING
SPEC