Components
21
EMU26342
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
NOTICE
ECM00661
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be
trailered in the normal running position,
use an additional support device to secure
it in the tilt position.
EMU31422
Cowling lock lever (pull up type)
To remove the top cowling, pull up the cowl-
ing lock lever(s) and lift off the cowling. To in-
stall the top cowling, place it in its original
position, and then move the cowling lock le-
ver(s) downward to lock it in place.
TIP:
When installing the cowling, check to be
sure it fits properly in the rubber seal.
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
42 Nm (4.28 kgf-m, 31.0 ft-lb)
U6P27AE0.book Page 21 Friday, December 6, 2013 6:17 PM
