Maintenance
54
NOTE:
If the shear pin equipped: it is designed to
break if the propeller hits a hard underwater
obstacle to help protect the propeller and
drive mechanism. The propeller will then
spin freely on the shaft. If this happens, the
shear pin must be replaced.
EMU29193
Removing the propeller
1.
Straighten the cotter pin and pull it out
using a pair of pliers.
2.
Remove the propeller nut, washer, and
spacer (if equipped).
3.
Remove the propeller and thrust wash-
er.
EMU29211
Removing the propeller
1.
Straighten the cotter pin and pull it out
using a pair of pliers.
2.
Remove the propeller nut and washer.
3.
Remove the deflector, propeller, and
thrust washer.
EMU29230
Installing the propeller
CAUTION:
ECM00340
●
Be sure to install the thrust washer be-
fore installing the propeller, otherwise
the lower case and propeller boss
could be damaged.
●
Be sure to use a new cotter pin and
bend the ends over securely. Otherwise
the propeller could come off during op-
eration and be lost.
1.
Apply Yamaha marine grease or a cor-
rosion resistant grease to the propeller
shaft.
2.
Install the spacer(if equipped), thrust
washer, and propeller on the propeller
shaft.
3.
Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
1
2
5
3
4
ZMU05053
1. Cotter pin
2. Propeller nut
3. Deflector
4. Propeller
5. Washer
6. Thrust washer
1
2
5
6
3
4
ZMU04420
Summary of Contents for F9.9D
