Operation
59
EMU27823
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU42196
Procedure for stopping engine (6X6
switch)
The engine can be turned off either by press-
ing the Start/Stop button or by turning the
main switch to the “
” (off) position.
Situations when stopping engine from main
station (dual-station models) or helm (single-
station models)
(1) Turn the main switch to “
” (off) or
press the Start/Stop button until the en-
gine stops completely.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to “
” (off).
(2) If the Start/Stop button was pressed to
stop the engine in step (1), turn the main
switch to “
” (off).
(3) Remove the key if the boat will be left un-
attended.
Situations when stopping engine from sub
station (dual-station models)
(1) Press the Start/Stop button until the en-
gine stops completely.
(2) Turn the main switch to “
” (off) on the
main station.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to “
” (off) on the main station.
(3) Remove the key if the boat will be left un-
attended.
EMU27865
Trimming outboard motor
EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can cau-
se boat instability and can make steering
1. Main switch
1. Start/Stop button
ON
OFF
START
1
1
1. Start/Stop button
1
U6KNK0E0.book Page 59 Monday, November 7, 2022 10:23 AM
