Operation
67
the boat, sea conditions, and running speed.
EMU27889
Adjusting trim angle (Power trim and
tilt)
WARNING
EWM00754
Be sure all people are clear of the out-
board motor when adjusting the trim
angle. Body parts can be crushed be-
tween the motor and the clamp bracket
when the motor is trimmed or tilted.
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“
” (up).
To lower the bow (trim-in), press the switch
“
” (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EMU27893
Adjusting trim angle for hydro tilt
models
WARNING
EWM00492
Stop the engine before adjusting the
trim angle.
Be sure all people are clear of the out-
board motor when adjusting the trim
angle, also be careful not to pinch any
1. Trim operating angle
1. Power trim and tilt switch
1. Power trim and tilt switch
DN
UP
1
ZMU01781
6BG-9-3F-E0.book 67 ページ ２０１８年１１月１日 木曜日 午後５時１分
©2020
Yamaha
Motor
Corporation
