Maintenance
57
5.
Check that the tilt rod and trim rods are
free of corrosion or other flaws.
6.
Activate the tilt-down switch until the trim
rods have retracted completely into the
cylinders.
7.
Activate the trim-up switch until the tilt rod
is fully extended. Unlock the tilt support
lever.
8.
Tilt the outboard motor down. Check that
the tilt rod and trim rods operate smooth-
ly.
NOTE:
Consult your Yamaha dealer if any operation
is abnormal.
EMU29171
Checking propeller
WARNING
EWM00321
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller.
●
Before inspecting, removing, or install-
ing the propeller, remove the spark plug
caps from the spark plugs. Also, place
the shift control in neutral, turn the main
switch to “
” (off) and remove the key,
and remove the lanyard from the engine
stop switch. Turn off the battery cut-off
switch if your boat has one.
●
Do not use your hand to hold the propel-
ler when loosening or tightening the
propeller nut. Put a wood block between
the anti-cavitation plate and the propel-
ler to prevent the propeller from turning.
Checkpoints
●
Check each of the propeller blades for
wear, erosion from cavitation or ventilation,
or other damage.
●
Check the propeller shaft for damage.
ZMU01941
ZMU01897
U6P212E0.book Page 57 Monday, June 6, 2005 4:23 PM
Summary of Contents for F250 LF250
