Yamaha F225F, Service Manual

Page: 508 / 576

9-29
BRKT
Bracket unit
12. Inject grease into the grease nipples until
grease comes out from the bushings
e
.
Adjusting the trim sensor
After tilting the swivel bracket up, make
sure to support it using the tilt stop lever.
Otherwise, the swivel bracket could sud-
denly lower.
1. Fully tilt the swivel bracket up, and then
support it using the tilt stop lever
a
.
2. Loosen the trim sensor screws
b
.
3. Adjust the position of trim sensor, and
then tighten the trim sensor screws
b
temporarily.
TIP:
• To decrease the resistance, turn the trim
sensor cam in direction
a
.
• To increase the resistance, turn the trim
sensor cam in direction
b
.
4. Fully tilt the swivel bracket down.
5. Measure the trim sensor setting
resistance. Check that the resistance is
within specification.
Self-locking nut
o
:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
Grease nipple
t
:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
t
t
t
r
s
t
q
p
o
n
n
t
d
e
a
a
b
b