Trouble Recovery
92
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40983
Power trim and tilt unit will not oper-
ate
WARNING
EWM02331
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard mo-
tor can be tilted manually.
1.
Stop the engine.
2.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
3.
Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU44521
Water separator-alert indicator blinks
while cruising
WARNING
EWM02543
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
Some fuel will spill during this proce-
dure. Catch the fuel in a rag. Wipe up any
spilled fuel immediately.
The fuel filter must be reassembled
carefully with the O-ring and filter cup in
place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion hazard.
If the water separator-alert indicator blinks,
perform the following procedure.
1.
Stop the engine.
2.
Remove the top cowling.
3.
Disconnect the water detection switch
coupler.
NOTICE:
Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
[ECM01951]
1. Fuse puller
1. Manual valve screw
1
ZMU04337
U6DV72E0.book Page 92 Friday, December 19, 2014 3:38 PM
