Yamaha F200B, Service Manual

Page: 83 / 579

3-14
3
1. Remove the engine ECM cover
1
, and
then remove the plug
2
.
2. Install the water pressure sensor
3
to
the water pressure sensor adapter
4
,
and then tighten the water pressure sen-
sor
3
to the specified torque.
3. Install a new gasket 5 and the water
pressure sensor assembly
a
, and then
tighten the water pressure sensor
adapter
4 to the specified torque.
4. Remove the cap, and then connect the
water pressure sensor coupler
b
.
5. Install the engine ECM cover.
Installing the rigging grommet
1. Route each harness through the proper
hole in the rigging grommet. See “Rig-
ging grommet description” (3-9) for the
detailed description of the rigging grom-
met.
2. Align the white tape
a
on the battery
cable with the outer end of the rigging
grommet.
3. Install the retaining plate
1
.
4. Install the rubber seal
2
.
TIP:
Make sure that the rubber seal is installed
securely.
Water pressure sensor 3 :
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Water pressure sensor adapter
4
:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
1
2
3
4
5
4
a
4
W
b
a
1
2
Rigging grommet mounting