Yamaha F200B, Service Manual

Page: 546 / 579

10-5
MNT
Maintenance
Checking the engine oil level
1. Place the outboard motor in an upright
position.
NOTICE: If the outboard
motor is not level, the oil level indi-
cated on the dipstick may not be cor-
rect.
2. Start the engine and warm it up for 5–10
minutes.
3. Stop the engine and leave it off for 5–10
minutes.
4. Remove the top cowling.
5. Remove the dipstick
1
and wipe it clean.
6. Insert the dipstick
1
completely for a
correct measurement and remove it
again.
7. Check that the oil level indicated on the
dipstick
1
is between the upper mark
a
and the lower mark
b
. If the engine oil is
not at the proper level, add or extract
engine oil.
Checking the engine start switch and
engine shut-off switch
1. Check that the engine starts when the
engine start switch is turned to START.
2. Check that the engine stops when the
engine start switch is turned to OFF.
È
703 remote control model
É
704 remote control model
3. Check that the engine stops when the
clip is removed from the engine shut-off
switch.
b
a
1
ON
OFF START
È
ON
START OFF
É
È