Yamaha F200B, Service Manual

Page: 538 / 579

BRKT
Bracket unit
9-63
Installing the trim ram
When assembling the PTT unit, do not use
a rag. Otherwise, dust and particles could
get on the PTT unit components, causing
poor performance.
1. Hold the PTT body
1
.
2. Fill the trim cylinders with the recom-
mended fluid to the proper level
a
.
3. Install the trim ram assemblies into the
PTT body
1
, and then tighten the trim
cylinder end screws
2
to the specified
torque.
Installing the tilt ram
When assembling the PTT unit, do not use
a rag. Otherwise, dust and particles could
get on the PTT unit components, causing
poor performance.
1. Place the tilt cylinder end screw 1 at the
position
a
.
2. Fill the tilt cylinder with the recommended
fluid to the proper level
b
.
3. Add a small amount of the recommended
fluid through the PTT body hole
c
.
Pipe joint adapter
6
:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
Pipe joint
9
and
0
:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
1
2
3
4
7
5
6
8
0
9
1
a
Cylinder-end screw wrench 3 :
90890-06568
Trim cylinder end screw
2
:
160 N·m (16.0 kgf·m, 118.0 ft·lb)
1
2
2
3