Yamaha F200B, Service Manual

Page: 524 / 579

BRKT
Bracket unit
9-49
Installing the PTT motor
• When assembling the PTT unit, do not
use a rag. Otherwise, dust and particles
could get on the PTT unit components,
causing poor performance.
• Do not reuse an O-ring, always replace it
with a new one.
1. Install the joint
1
.
2. Fill the gear pump housing with the rec-
ommended fluid to the proper level
a
.
3. Turn the joint
1
using a screwdriver to
remove any air between the pump gear
teeth.
4. Remove all of the air bubbles using a
syringe or suitable tool.
5. Install a new O-ring
2
and the PTT
motor
3
, and then tighten the PTT motor
bolts
4
to the specified torque.
TIP:
Align the protrusion
b
on the armature shaft
with the slot
c
in the joint.
Reservoir bolt
6
:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
Reservoir cap
8
:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
Recommended PTT fluid: ATF Dexron II
1
a
PTT motor bolt
4
:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
3
4
4
2
1
b
c