Yamaha F200B, Service Manual

Page: 447 / 579

8-84
8
Assembling the reverse gear
Do not reuse a bearing or circlip, always
replace it with a new one.
1. Install a new needle bearing to the speci-
fied depth
a
.
2. Install a new circlip
3
.
Assembling the oil seal housing
1. Assemble the oil seal housing. See
“Assembling the oil seal housing” (8-27).
Installing the drive shaft
1. Install the thrust bearing and reverse
gear assembly into the lower case.
2. Install the drive shaft and oil seal hous-
ing. See steps 2–5 in “Installing the drive
shaft” (8-28).
Installing the propeller shaft housing
assembly
Do not reuse an O-ring, always replace it
with a new one.
1. Install new O-rings to the propeller shaft
housing.
2. Set the shift rod joint
1
and dog clutch
2
to the N position.
3. Install the propeller shaft housing assem-
bly, cover, and water inlet covers. See
steps 4–6 in “Installing the propeller shaft
housing assembly” (8-29).
Installing the shift rod
Do not reuse an oil seal or O-ring, always
replace it with a new one.
1. Check that the shift rod joint is in the N
position, and then install the shift rod
1
,
the spring
2
, a new O-ring
3
, the plate
4
, and a new oil seal
5
.
Needle bearing attachment 1 :
90890-06653
Driver rod SS 2 : 90890-06604
Depth
a
:
6.75–7.25 mm (0.2657–0.2854 in)
1
2
a
3
L
F
R N F
1
2
Drive shaft and lower case (FL200B)