9-34
PTT unit
0
1
2
3
4
5
6
7
8
9
10
A
Checking the hydraulic pressure
Check the hydraulic pressure. If out of speci-
fication, check the internal parts.
1.
Fully extend the PTT rams.
2.
Remove the reservoir cap
a
, and then
check the fluid level in the reservoir.
WARNING! Make sure that the PTT
rams are fully extended when removing
the reservoir cap
a
, otherwise fluid can
spurt out from the unit due to internal
pressure.
TIP:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the reservoir cap is removed.
3.
If the fluid is below the correct level, add
the recommended fluid.
4.
Install the reservoir cap
a
, and then
tighten it to the specified torque.
5.
Remove the circlip
b
, and then remove
the manual valve
c
.
6.
Install the special service tools
d
and
e
.
TIP:
Quickly install the special service tools before
any fluid flows out of the hole.
7.
Connect the PTT motor leads to the
battery terminals to fully retract the PTT
rams.
Recommended PTT fluid: ATF Dexron
ΙΙ
g
h
a
Reservoir cap
a
:
0.7 N·m (0.07 kgf·m, 0.5 ft·lb)
Up relief fitting
d
: 90890-06773/06838
Hydraulic pressure gauge
e
:
90890-06776/06800
b
c
d
e
B
B/W
Summary of Contents for F150B
