Operation
57
EMU28061
Shallow water
EMU32851
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
NOTICE
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32922
Procedure for power trim and tilt models
1.
Place the remote control lever in neutral.
2.
Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch.
WARNING! Using the power
trim and tilt switch on the bottom
cowling while the boat is moving or
engine is on could increase the risk of
falling overboard and could distract
the operator, increasing the risk of
collision with another boat or an ob-
stacle.
[EWM01850]
3.
To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU28195
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
ter.
Cruising in muddy, turbid, or acidic water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(see page 13) if you use the outboard motor in
acidic water or water with a lot of sediment in
it, such as muddy or turbid (cloudy) water. Af-
ter operating in such water, flush the cooling
passages with fresh water to prevent corro-
sion. Also rinse the outside of the outboard
motor with fresh water.
N
ZMU04588
U63P2AE0.book Page 57 Monday, March 1, 2010 1:49 PM