Operation
52
2.
After stopping the engine, disconnect the
fuel line or close the fuel cock if there is a
fuel joint or a fuel cock on the boat.
3.
Tighten the air vent screw on the fuel tank
cap (if equipped).
4.
Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling the
cord and removing the clip from the engine
shut-off switch, then turning the main switch
to “
” (off).
EMU27862
Trimming outboard motor
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
ON
OFF
START
ZMU04599
OFF
ON
OFF
ON
ZMU04600
OFF
OFF
ON
ON
ZMU05833
1. Trim operating angle
U63P2AE0.book Page 52 Monday, March 1, 2010 1:49 PM
