Yamaha EXCITER, Owner'S/Operator'S Manual

Page: 98 / 113

5
5-4
T
ROUBLESHOOTING
& S
PECIAL
P
ROCEDURES
To connect the jumper cables:
1. Connect the positive (+) terminal of
the dead battery to the positive ter-
minal (+)of the booster battery with
the positive jumper cable.
2. Connect one end of the negative (–)
jumper cable to the negative (–) ter-
minal of the booster battery.
3. Connect the other end of the nega-
tive (–) cable to an unpainted bolt
on the cylinder head.
___________
Be sure all connections are secure
and correct before attempting to start
the engine. Any wrong connection
may damage the electrical system.
4. Start the engine, then disconnect
the cables by reversing the above
steps.
___________
Do not turn the starter motor for
more than 5 seconds. If the engine
does not start in 5 seconds, release
the starter switch and try again after
15 seconds. Continuous cranking for
more than 5 seconds will discharge
the battery and the engine will not
start. The starter motor may also be
damaged if it is engaged continuous-
ly for more than five seconds.
JET PUMP CLEAN-OUT
PROCEDURE
________________
SEVERE INJURY OR DEATH MAY
RESULT IF YOU IGNORE ANY OF
THE FOLLOWING:
●
Turn off and remove ignition key,
remove lanyard, and wait for all
movement to stop before remov-
ing access port caps.
●
Never override the interlock to
run engine with hatch open.
●
The impeller has sharp edges. Be
careful when reaching into jet
pump area.
If weeds or debris get caught in the
intake or impeller, cavitation can occur,
and though the engine speed rises, for-
ward thrust will decrease. If this condi-
tion is allowed to continue, pump dam-
age can occur and the engine may
overheat and seize. If there is any sign
that the jet intake or impeller is clogged
with weeds or debris, follow this
cleanout procedure.
1. Turn off and remove ignition key,
remove lanyard, and wait for all
movement to stop.
2. Lift the hatch on the rear platform.
WARNING
CAUTION:
CAUTION: