Yamaha EXCITER SE, Owner'S Manual

Page: 61 / 106

3) Wash down the hull, helm, and the
jet drive unit with fresh water.
4) Remove the two hull drain plugs
and the two engine compartment
drain plugs. Rinse the engine com-
partment with a small amount of
fresh water. Be careful not to get
water on the carburetor or electrical
components. Allow any water in the
bilge to drain out. After the water
has drained, wipe the engine com-
partment and bilge with dry rags.
Reinstall all drain plugs.
NOTE:
_________________
This boat is equipped with an electric
bilge pump that automatically removes
excess water from the bilge while you
are underway. However, some residual
water remains that must be drained by
removing the drain plug.
___________
Tighten the hull drain plugs secure-
ly before launching the Jet Boat.
Clean any foreign material, such as
dirt or sand, from the threads before
installing the drain plugs.
5) Spray a rust inhibitor, such as
Yamaha Silicone Protectant and
Lubricant, on metallic parts to mini-
mize corrosion.
CAUTION:
3
3-21
O
PERATION