20
Basic Operation
EMX88S/EMX68S—Owner’s Manual
Basic Operation
This section explains basic operation of the EMX88S/EMX68S.
Connecting microphones
and instruments
1
Before connecting mics or instruments,
make sure that the power of all equip-
ment (where applicable) is turned off.
Also make sure that the level controls of
each channel of the EMX88S/EMX68S
and the MASTER control of the MAIN sec-
tion are turned down.
2
Connect cables to your mics and instru-
ments, and insert the other end of the
cable firmly into the appropriate Low-Z/
Hi-Z jack or the MIC/LINE jack.
3
Turn the power on in the order of periph-
eral devices
➞
EMX88S/EMX68S.
4
Set the MAIN section MASTER control to
the “
√
√
√
√
” position.
Adjusts the stereo image of each channel using
the PAN or BAL/PAN controls. (Adjust the bal-
ance between the left and right volume levels of
the sound sources connected to the LINE con-
nectors L/R.)
5
While speaking into the mic (while play-
ing the instrument), adjust the channel
LEVEL control so that the 0 LED of the
MAIN section peak level meter lights
occasionally.
6
If you wish to adjust the tone of each
channel, rotate the equalizer controls as
desired.
7
Use the MAIN section graphic equalizer
and MASTER control to adjust the overall
volume and tone.
Sending an independent
mix to the monitor speakers
1
Set the MONITOR section MASTER con-
trol to the “
√
√
√
√
” position.
2
Adjust the MONITOR control to increase
the level of the channel you want to hear
from the monitor speaker, and also adjust
so that the peak level meter 0 LED of the
monitor section lights up occasionally.
3
Use the graphic equalizers and MASTER
controls of the MAIN/MONITOR sections
to adjust the overall volume and tone.
Using the digital effect
The EMX88S/EMX68S has a built-in digital
effect, allowing reverberation or ambiance to be
added to vocals or instrumental sounds.
1
Connect a mic or instrument to the
desired channels, and adjust the volume
and tone.
2
Press the DIGITAL EFFECT ON switch of
the DIGITAL EFFECT section.
3
Use the PROGRAM selector of the DIGI-
TAL EFFECT section to select the effect
type.
4
Raise the EFFECT control of the channels
to which you wish to apply the digital
effect.
5
Use the MAIN/MONITOR section EFFECT
RTN control to adjust the level of the
sound processed by the effect.
Note: When connecting a line level device to
channels 1–6 (EMX88S), 1–4 (EMX68S), turn
on the PAD switch.
You cannot use a channel’s Low-Z and Hi-Z
jacks, and MIC and LINE jacks at the same
time.
Note: When turning the power off, reverse this
sequence.
Note: The MONITOR controls are not affected
by the level settings of each channel. This allows
you to create a mix that is independent of the
MAIN section.
Note: If the effect sound is distorted even if the
EFFECT RTN is turned all the way down, lower
the EFFECT controls of each channel.