MENU
EAD10 Reference Manual (Advanced)
30
Trigger
WaitTime : Wait Time
This parameter is used to set the time until the target pad detects a trigger signal. Set this parameter to adjust the time so that the trig-
ger signal is detected at its peak and that the strength for striking the pad corresponds to the volume of the sound produced.
1 to 64 (msec)
RimGain : Rim Gain
Sets the rim gain level for a two piezo pad such as the DT50S connected to the mono × 2 input jack. This parameter is only effective
when the input mode is set to “paired.”
1 to 127
H/R Balance : H/R Balance
It sets the balance between the two piezo head and rim (H49 to H1, 0, R1 to R49). If the head sound is produced when the rim is
struck, increase the R value to make the rim sound louder. If the rim sound is produced when the head is struck, press the [–] button
to increase the H value, which makes the head sound louder.
This parameter is only effective when the input mode is set to “paired.”
H49 to H1, 0, R1 to R49
Trigger/Pad Type 4/4
Settings
Settings
Settings
