204
Chapter 10—Front Panel Operation
DME32—Owner’s Manual
Using Scene Recall Only
Scene Recall Only allows scenes to be recalled but prevents access to other functions.
1
Use the [UTILITY] button to select the “Setup protection level” function, as
shown below.
The UTILITY indicator lights up.
Note that if Full Protect mode is enabled, you won’t be able to select the “Setup protec-
tion level” function until you disable the protection. To do this, press the [PROTECT]
button, enter the correct password, and then press the [RECALL] button.
2
Use the DATA wheel or [INC] and [DEC] buttons to select “Scene recall only,”
as shown below.
The PROTECT indicator lights up.
3
Press the [UTILITY] button repeatedly until the UTILITY indicator goes out.
In Scene Recall Only mode, scenes can be recalled as normal, but scenes cannot be
stored. Components, parameters, and values can be selected and viewed in the normal
way, but parameters cannot be edited.
Only three utility displays are available in Scene Recall Only mode: the main display, the
Setup protection level display, and the SLOT display.
If Scene Recall Only mode is enabled and you want to edit component parameters, first
switch to Full Protect mode (see page 205), and then temporarily disable the protection
(see page 206).
SCENE NO.
CONFIGURATION
SCENE
XXXXXXXXXXXX
Full
X
protect
Setup
X
protection
X
level
_
0 i
SCENE NO.
CONFIGURATION
SCENE
XXXXXXX
Scene
X
recall
X
only
Setup
X
protection
X
level
_
0 i
