Restricting Access to the DME32
205
DME32—Owner’s Manual
Using Full Protect
Full Protect prevents access to all functions. It can be disabled temporarily by entering
the correct password, allowing editing by authorized users. See “Temporarily Disabling
the Protection System” on page 206 for more information.
1
Use the [UTILITY] button to select the “Setup protection level” function, as
shown below.
The UTILITY indicator lights up.
2
Use the DATA wheel or [INC] and [DEC] buttons to select “Full protect,” as
shown below.
The PROTECT indicator goes out.
3
Press the [UTILITY] button repeatedly until the UTILITY indicator goes out.
4
Press the [PROTECT] button.
The Shift to Protect Mode display appears, as shown below.
5
Press the [VALUE] button to enable Full Protect mode, or press the [PARAM-
ETER] button to cancel.
Full Protect mode is enabled and the PROTECT indicator lights up.
In Full protect mode, scenes cannot be stored or recalled. Components, parameters,
and values can be selected and viewed in the normal way, but they cannot be edited.
SCENE NO.
CONFIGURATION
SCENE
XXXXXXX
Scene
X
recall
X
only
Setup
X
protection
X
level
_
0 i
SCENE NO.
CONFIGURATION
SCENE
XXXXXXXXXXXX
Full
X
protect
Setup
X
protection
X
level
_
0 i
SCENE NO.
CONFIGURATION
SCENE
XXXXXXXXXX
No
XXXXXXX
Yes
Shift
X
to
X
Protect
X
Mode?
0 i
