DME32
33
Transmission
I
f [Program Change TX] is ON, this message is transmitted on the
[Tx CH] according to the settings of the [Program Change Assign
Table] when a scene is recalled.
If the scene memory number that was recalled is assigned to more
than one Program Change, the lowest-numbered Program Change is
transmitted.
If [Program Change ECHO] is ON, these messages are echoed.
STATUS
1100nnnn Cn
Program Change
DATA
nnnnnnn nn
Program No. (0–127)
4.3 Parameter Change
(byte operation for type 0x00: edit buffer)
Reception
These messages are received if [Parameter Change RX] is ON and
the [Rx CH] matches the Device Channel included in the SUB
STATUS of the message.
These messages are echoed if [Parameter Change ECHO] is ON.
When these messages are received, the corresponding parameter is
controlled.
Transmission
If [Parameter Change TX] is ON, this message is transmitted on the
[Tx CH] Device Channel when a parameter not specified in the
[Control Change Assign Table] is adjusted.
These messages are transmitted without change if [Parameter Change
ECHO] is ON.
STATUS
11110000 F0
System Exclusive Message
ID No.
01000011 43
Manufacturer's ID No.(YAMAHA)
SUB STATUS
0001nnnn 1n
parameter change or response for request
n=0-15 (Device Channel No.1-16)
GROUP ID
00111110 3E
group ID (digital mixer)
MODEL ID
00000101 05
Device code (DME32)
PARAM TYPE
00000000 00
byte operation for edit buffer
DATA
0000aaaa dd1
Parameter No. (H high order bit)
0000bbbb dd2
Parameter No. (H low order bit)
0000cccc dd3
Parameter No. (L high order bit)
0000dddd dd4
Parameter No. (L low order bit)
0000eeee dd5
Parameter value (H high order bit)
0000ffff dd6
Parameter value (H low order bit)
0000gggg dd7
Parameter value (L high order bit)
0000hhhh dd8
Parameter value (L low order bit)
EOX
11110111 F7
End Of Exclusive
