Set Input Compressor
1.
Select the channel
2.
On SELECTED CHANNEL / DYNAMICS, press [COMP ON] button
if unlit.
3.
On SELECTED CHANNEL / DYNAMICS, press [DISPLAY].
4.
Keep pressing this button to locate “Compressor Library” page.
5.
Recall program desired and edit if needed…
OR…
1.
Select the channel.
2.
On SELECTED CHANNEL / DYNAMICS, press [COMP ON] button
if unlit.
3.
Press [GATE/COMP] to light [COMP] indicator.
4.
Adjust [THRESHOLD] [RATIO] [ATTACK] [RELEASE] [GAIN] as
needed.
Set Input Equalization
1.
Select the channel.
2.
On SELECTED CHANNEL / EQUALIZER, press [EQ ON] button
if unlit.
3.
On SELECTED CHANNEL / EQUALIZER, press [DISPLAY].
4.
Keep pressing this button to locate “Equalizer Library” page.
5.
Recall program desired and edit if needed…
OR…
1.
Select the channel.
2.
On SELECTED CHANNEL / EQUALIZER, press [EQ ON] button
if unlit.
3.
Adjust [FREQUENCY] [Q] [GAIN] for each band as needed.
NOTE: [FREQUENCY] & [Q] toggle on same control by pushing the knob.
≠
Output Channel Setup
NOTE: Assume the output patch is completed.
Select the Output Channel
1.
Press LAYER / [MASTER].
2.
Select the output channel (bus master) by touching the fader.
3.
If fader touch sensitivity is turned off, press [SEL].
