RUNNING H/F 1
6
Follow the procedure below to connect speakers to this
unit. For information on your speakers, refer to the
owner’s manual for the speakers.
• Do not connect the power cable of this unit until all cable
connections are completed.
•
Be sure to connect the left channel (L), right channel (R), “
+
” (red)
and “
–
” (black) properly. If the connections are faulty, no sound
will be heard from the speakers, and if the polarity of the speaker
connections is incorrect, the sound will be unnatural and lack bass.
• Do not let the bare speaker wires touch each other or do not let
them touch any metal part of this unit. This could damage this
unit and/or the speakers.
• Use speakers with the specified impedance shown on the rear
panel of this unit.
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and twist
the exposed wires of the cable together to
prevent short circuits.
2
Unscrew the knob
.
3
Insert one bare wire into the hole in the side
of each terminal. And then tighten the knob
to secure the wire.
Connect the SUBWOOFER OUT jack on this unit
to the INPUT jack on the subwoofer using a
subwoofer cable.
Do not connect the power cable of this unit or subwoofer until all
cable connections are completed.
CONNECTING SPEAKERS AND SUBWOOFER
Connecting speakers
Notes
+
+
OPTICAL
SPEAKERS
OUT
SUBWOOFER
_
_
DIGITAL
OUT
IN
AUX 2
R speaker
L speaker
10 mm
Connecting a subwoofer
Note
Red: positive (+)
Black: negative (–)
Red:
positive (+)
Black:
negative (–)
+
IN
SPEAKERS
OUT
SUBWOOFER
_
A
IN
AUX 2
+
_
INPUT
Subwoofer
00EN_00_CRX-M170_G.book Page 6 Wednesday, July 27, 2005 6:11 PM
