Installation
This section gives a step-by-step guide to installing the CRW8424S drive. Make
sure you have all the necessary tools.
First Steps
Once you have taken the CRW8424S drive out of its packaging, you should
immediately note down the serial number shown on the top of the drive
together with a barcode. You may need to refer to this number when requesting
User Support services. In the box below the following diagram, write down the
10-character serial number (consisting of 3 letters followed by 7 digits).
Before fitting the CRW8424S drive into the computer, you need to set up the
drive using the jumper switches located at the rear of the unit. You’ll need to set
the following:
●
SCSI ID number
●
Parity check
●
Termination
●
Block size
Drive’s serial number
(3 l 7 digits)
Serial No.
8
8424S_e.qx 10/27/99 9:55 PM Page 15
