16
CVP-601 Reference Manual
V
o
ices – Pla
y
ing
the K
e
yboar
d –
2
The Organ Flute Voices selected from the [ORGAN FLUTES] button can be edited by adjusting the footage
levers, adding the attack sound, applying effects and equalizer, etc.
NOTICE
After editing, go to the Voice Selection display by pressing the [I] (PRESETS) button and save the setting. The settings will be lost if you
select another Voice or turn the power to the instrument off without executing the Save operation.
FOOTAGE Page
Refer to the Owner’s Manual, chapter 2.
VOLUME/ATTACK Page
EFFECT/EQ Page
Same parameters as in the VOICE SET “EFFECT/EQ” Page explained on
Editing Organ Flutes Parameters
[1
]
VOL (Volume)
Adjusts the overall volume of the Organ Flutes. The longer the graphic
bar, the greater the volume.
[2
]
RESP
(Response)
Affects both the attack and release (
) portion of the sound,
increasing or decreasing the response time of the initial swell and
release, based on the FOOTAGE controls. The higher the value, the
slower the swell and release.
[3
]
VIB. SPEED
Determines the speed of the vibrato effect controlled by the VIBRATO
ON/OFF ([F]/[G] buttons) and VIBRATO DEPTH ([H] button).
[4
]
MODE
The MODE control selects one of two modes: FIRST and EACH. In the
FIRST mode, attack (percussive sound) is applied only to the first notes
played and held simultaneously; while the first notes are held, any sub-
sequently played notes have no attack applied. In the EACH mode,
attack is applied equally to all notes.
[5
] –
[7
]
4', 2 2/3', 2'
These determine the attack sound volume of the ORGAN FLUTE
Voice. The 4', 2-2/3' and 2' controls increase or reduce the volume of
attack sound at the corresponding footages. The longer the graphic bar,
the greater the attack sound volume.
[8
]
LENG (Length)
Affects the attack portion of the sound producing a longer or shorter
decay immediately after the initial attack. The longer the graphic bar,
the longer the decay.
Same as the
FOOTAGE Page.
