96
CLP-970A
CLP-970A/970AM/970AC:
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
The parts shown in the “Assembly Parts” illustra-
tion will be used. Follow the assembly instructions
and select the parts as needed.
1.
Attach the side panels to the pedal box.
Place the plastic bag that contained the side
panels on the floor when assembling the stand
to prevent scratches to the floor or stand.
2.
Attach the rear panel.
Have a Phillips-head (+) screwdriver ready.
6 x 25 mm
round-head screws x4
4 x 12 mm
round-head screws x2
Cord holders x 2
6 x 16 mm
flat-head screws x4
4 x 20 mm
tapping screws x4
Assembly Parts
1
2
3
4
pedal box
rear panel
side
panel
(left)
side
panel
(right)
Bundled pedal cord inside
AC power cord
main unit
side panel
(right)
side panel
(left)
(1) Untie and straighten out the
bundled cord attached to the
bottom of the pedal box.
Don’t discard the vinyl tie,
you’ll need it later in step 6.
(2) Use the four long
round-head
screws
1
to
attach the pedal
box. First attach
one side panel,
then attach the
other side panel.
Make sure the
indented surface on
the side panel and the
rear surface on the
pedal box will match
correctly, without
creating a step.
L
R
(1) With the rear
panel on the
feet’s
protruding
edge, align the
panel with the
groove and
secure the top
of the panel.
(3) Secure the
bottom of the
rear panel to the
pedal box using
four tapping
screws
4
.
(2) Secure the top of the
rear panel to the side
panel brackets using
two thin round-head
screws
3
.
CLP-970A.E.book Page 96 Monday, December 11, 2000 5:42 PM
