Keyboard Stand Assembly
CLP-265GP
Owner’s Manual
ENGLISH
53
2.
Attach two front legs and a rear leg.
Refer to the diagram below to verify the orienta-
tion of the legs.
Install and tighten four 6 x 40 mm screws on each
leg, starting with one of the front legs.
3.
Install the pedal box.
3-1
Remove the twist tie that affixes the pedal cord to
the upper portion of the pedal box.
3-2
Align the cord with the groove on the unit, and
attach the pedal box using four 6 x 20 mm screws.
3-3
Insert the pedal cord plug into the pedal connec-
tor. Insert the plug so the arrow side faces front
(toward the keyboard).
If the plug will not go in easily, do not force it.
Double-check the orientation of the plug, then
try again.
3-4
Attach the cord holder on the unit as shown in
the illustration below, then use the cord holder to
affix the pedal cord.
4.
Raising the unit to the standing position.
Use the front legs as support to raise the unit.
Rear leg
Front leg
Front leg
Twist tie
3-3
3-4
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key
cover.
Summary of Contents for Clavinova CLP-265GP
Page 69: ...MEMO ...
Page 70: ...MEMO ...
