Yamaha Clavinova CLP-170, Owner'S Manual

Page: 112 / 124

112
CLP-170/150
CLP-150: Keyboard Stand
Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install
all parts in the correct direction. Please assemble in
accordance with the sequence given below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing
assembly of each unit.
• To disassemble, reverse the assembly sequence given
below.
Remove the following parts from the package.
1.
Attach the side panels to the pedal box.
2.
Attach the rear panel.
Have a Phillips-head (+) screwdriver ready.
Assembly Parts
6
×
25 mm long screws
×
4 1
4
×
12 mm thin screws
×
2
3
Cord holders
×
2
6
×
16 mm short screws
×
6
2
4
×
20 mm tapping
screws
×
4 4
Pedal box
Rear panel
Main unit
Bundled pedal cord inside
AC power cord
Side panel
(left)
Side panel
(right)
side
panel
(left)
side
panel
(right)
(1) Untie and straighten out
the bundled cord
attached to the bottom of
the pedal box.
(2) Use the four 6
×
25 mm long screws
1 to attach the pedal box. First
attach one side panel, then attach
the other side panel.
R
L
(3) Secure the bottom of
the rear panel to the
pedal box using four
4
×
20 mm 4 tapping
screws.
(2) Secure the top of the rear panel
to the side panel brackets using
two 4
×
12 mm 3 thin screws.
(1) Place the bot-
tom edge of the
rear panel in the
grooves of the
legs, and then
fasten the upper
edge.