Yamaha CL5, Quick Start Manual

Page: 3 / 6

Pairing the Remote Control to the CL0 Device
You must pai r the remote control to the CL 0 device before
you can use the CL0 device.
1
Turn on the CL0 device.
The device turns on in paring mode. If it is not in paring
mode, hold the CL0 power button for 3 seconds.
2
On the remote control, h old the MENU and keys.
The device beeps until the remote control and device are
paired.
CL0 Remote Control
Quick Start Manual 3
À
Turn to highlight.
Push to select
Á
Returns to previous the screen or menu.
Â
Opens the menu for that page.
Ã
Hold
to assign a shortcut key to the current page.
Press to open the assigned page.
.
Ä
Press to adjust the backlight brightness
BACK MENU
1 2
Yamaha Autopilot
WARNING
You are responsible for the safe and prudent operation of your
vessel. The autopilot is a tool that enhances your capability to
operate your boat. It does not relieve you of the responsibility of
safely operating your boat. Avoid navigational hazards and
never leave the helm unattended.
Always be prepared to promptly regain manual control of your
boat.
Learn to operate the autopilot on calm and hazard-free open
water.
Use caution when operating the autopilot near hazards in the
water, such as docks, pilings, and other boats.
The autopilot system continuously adjusts the steering of your
boat to maintain a constant heading (heading hold).
When the chartplotter is connected to a compatible Yamaha
autopilot system, you can view the autopilot information using
the Yamaha autopilot screen and overlay bar ( Yamaha
Autopilot , page 2 ). For information about compatible Yamaha
autopilot systems, contact your Yamaha dealer.
When the chartplotter is connected to a compatible Garmin
®
autopilot system, you can engage and control the autopilot from
the chartplotter ( Autopilot , page 38 ). For information about
compatible Garmin autopilot systems, go to garmin.com .
Actual heading
Intended heading (heading the autopilot is steering toward)
Yamaha Autopilot Settings
From a Yamaha engine screen, select Menu > Autopilot
Setting .
Pattern Set : Allows you to select an autopilot pattern.
Direction : Sets a port or starboard direction for the pattern.
Spacing : Sets the spacing for the pattern.
Length : Sets the length of the pattern.
Amplitude : Sets the angle for the zigzag pattern.
Initial Radius : Sets the radius of the spiral pattern.
Final Track Point Mode : Sets the mode for the autopilot when it
reaches the end of a route.
Offset Distance : Sets an offset distance to navigate parallel to
a route.
Yamaha Autopilot
Screen
Yamaha Autopilot Overlay Bar
Autopilot mode
Actual heading
Intended heading (heading the autopilot is steering toward)
Opens the full autopilot screen and menu
WARNING
Only replace batteries with AAA batteries. Using other batteries
presents a risk of fire or explosion.
Contact your local waste disposal department to dispose of the
device/batteries in accordance with applicable local laws and
regulations