6-3
NOTE:
●
If the engine fails to start, release the
start switch, then push the start switch
again. Pause a few seconds before the
next attempt. Each cranking should be
as short as possible to preserve bat-
tery energy. Do not crank the engine
more than 10 seconds on each at-
tempt.
●
If the battery is discharged, pull the re-
coil starter to start the engine.
7. If the engine is started with the starter
(choke) in position
1
, the starter
(choke) should be returned to position
2
to warm up the engine. If the engine
is started with the starter (choke) in
position
2
, keep the starter (choke) in
this position to warm up the engine.
8. Continue warming up the engine until
it idles smoothly and return the starter
(choke) to position
3
before riding.
CAUTION:
See the “Engine break-in” section prior to
operating engine for the first time.
EBU00180
Starting a warm engine
To start a warm engine, refer to the “Start-
ing a cold engine” section. The starter
(choke) should not be used. The throttle
should be opened slightly.
EBU00182
Warming up
To get maximum engine life, always warm
up the engine before starting off. Never ac-
celerate hard with a cold engine! To see
whether or not the engine is warm, check if
it responds to the throttle normally with
the starter (choke) turned off.
All manuals and user guides at all-guides.com
Summary of Contents for BIGBEAR YFM400NM
