31
AW2816
•
Even if the connector is difficult to insert, do not
attempt to insert it by applying excessive force.
Doing so may damage the hard disk, or you may
injure yourself.
•
When inserting the connector, be careful that it is
not mis-aligned up/down or left/right.
As shown in the illustration place the cover
plate with the attached hard disk back
onto the bottom panel of the AW2816,
and fasten the cover plate to the bottom
panel using the four screws that you
removed in step 4.
•
You must use the same screws that you removed in
step 4, or identical screws. Using longer screws may
damage the interior of the unit, or may cause elec-
trical shock.
•
Do not turn on the power of the AW2816 until all
options have been installed.
•
When you turn on the power of the AW2816 after
installing a new hard disk, formatting of the hard
disk will begin automatically.
Pull out the flat cable from inside the
AW2816, and plug the flat cable into the
connector of the hard disk as shown in the
illustration. Press both ends of the flat
cable connector to ensure that it is firmly
plugged in all the way.
Summary of Contents for AW2816
