En
21
Mount the unit on a wall
1
Attach the mounting template on a wall and mark for
the screw holes.
2
Remove the mounting template from the wall, then
install commercially available screws (as illustrated
below) at the points marked on the wall.
3
Hang the unit on the screws.
CAUTION
• When mounting the unit on a wall, all installation work
must be performed by a qualified contractor or dealer. The
customer must never attempt to perform this installation
work. Improper or inadequate installation could cause the
unit to fall, resulting in personal injury.
• To prevent the unit from falling, attach it to a wall
constructed of drywall (plasterboard).
• Make sure you use commercially available screws that
can support the weight of the installation (specified in Step
2 on the right). Using clamps other than specified screws,
such as short screws, nails, and two-sided tape, may
cause the unit to fall.
• Fix the cables in place where they will not become loose.
If your foot or hand accidentally gets caught on a loose
cable, the unit may fall.
• Do not lean on the unit or apply excessive force to the top
of the unit. Doing so may cause the unit to fall.
• Check that the unit is fixed securely after the installation.
Yamaha will bear no responsibility for any accidents
caused by improper installations.
HDMI
Tapes or thumbtacks
Mounting template (supplied)
Screw holes
HDMI
7 to 9 mm
(1/4" to 3/8")
4.5 to 6 mm (1/8" to 1/4")
4 mm (#8)
20 mm (3/4")
or more
HDMI
Mounting holes on
bottom of the unit
Touch panel
