Keyboard Stand Assembly
34
YDP-165, YDP-145, YDP-S55, YDP-S35 Owner’s Manual
You can watch a video of the assembly.
Check if you have all of the items indicated below.
NOTICE
Make sure to place the main unit on the polystyrene foam
pads that have been removed from the packages. Position the
pads so that they will not contact the speaker covers on the
bottom of the main unit.
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area.
1.
Align the side boards with each end
of pedal box, and lightly tighten
with flat head screws (6 × 20 mm)
for temporary fastening
These screws will be tightened securely later in
step 3.
2.
Attach the back board.
Depending on the model, the surface color of one
side of the back board may be different from the
other side. In this case, position the back board so
that the side facing the front (pedal side) matches
the color of the main unit.
2-1
Place the back board on each foot of side
boards.
2-2
Attach the top of the back board by
temporarily fastening the thin screws (4 ×
12 mm).
2-3
While pushing on the lower part of the side
boards from the outside, secure the bottom
ends of the back board using tapping screws
(4 × 20 mm) in the order from outside to
inside (
1
→
2
).
YDP-165, YDP-145 Assembly
Scan the QR code at left or access the
website below.
https://4wrd.it/ydp_assembly_video1
YDP-165
× 2
YDP-145
× 4
× 4
× 2
× 4
× 4
Cord holder
Speaker cover
Speaker cover
Polystyrene foam pads
Main unit
Back board
Pedal box
Side board (L)
Side board (R)
Flat head screws (6 × 20 mm)
Caps
Thin screws (4 × 12 mm)
Tapping screws
(4 × 20 mm)
Thick screws (6 × 16 mm)
AC adaptor
Power cord
Headphone hanger
Screws
(4 × 10 mm)
AC adaptor
Headphone hanger set
× 4
Side board (R)
Side board (L)
Pedal box
Flat head screws (6 × 20 mm)
Summary of Contents for ARIUS YDP-145
Page 45: ...45 ...
