YDP-135 Owner’s Manual
23
ENGLISH
Recording Your Performance
This function enables you to record your performance as a "User Song." Only one User Song is available.
Follow the steps below to record and play back your performance.
Recording Your Performance
NOTICE
Be careful not to erase the
recorded data.
After you record a
performance, the [PLAY]
button indicator lights up.
When this indicator remains
on, recording another
performance will erase the
recorded data.
You cannot engage Record
mode while a demo song is
playing.
The User song data is not
transmitted via MIDI.
Recording capacity
“Recording capacity” is the
maximum amount of
performance data that you
can record. This instrument’s
recording capacity is 65 KB
(approximately 11,000 notes).
NOTICE
After the recording is stopped
in step 4, it may take a short
time to store the recorded
data, during which the [REC]
and [PLAY] lamps are
flashing. In this situation,
never turn off the power.
Otherwise, all recorded data
will be lost.
If the metronome was on when
you started recording, you’ll
be able to keep time with the
metronome while recording,
but the metronome sound will
not be recorded.
You can save the recorded
user song to a computer. You
can also load the user song
data from a computer and
play it back on this instrument.
(See page 26.)
1
Make all the initial settings such as Voice and time signature.
Make the Voice settings (pages 16 and 19), time signature (page 21), and any other
desired settings (reverb, etc.) as necessary.
Use the [MASTER VOLUME] control to adjust the volume to a comfortable listening
level. You can also use the [MASTER VOLUME] control to adjust the volume level
during playback.
2
Press the [REC] button to engage the Record Ready mode.
The [REC] button indicator flashes.
Press the [REC] button again if you wish to cancel the Record mode.
3
Start recording.
Recording starts as soon as you play the keyboard.
Alternatively, press the [PLAY] button to start recording.
4
Press the [REC] button to stop recording.
Changing the settings for the recorded user song
Except for the time signature, you can change the initial settings of the recorded
User Song. To do this, engage Record mode, change the settings as you desire,
then stop recording without playing the keyboard.
For example, if you wish to change the Voice of the user song, press the [REC]
button to engage Record mode (see Step 2), then select a different Voice (see Step
1). Without playing the keyboard, press the [REC] button to stop recording (see
Step 4).