EMU00396
Installing the Propeller
c
C
8
Be sure to install the thrust washer
before installing the propeller, other-
wise the lower case and propeller boss
may be damaged.
8
Be sure to use a new cotter pin and
bend the ends over securely. Otherwise
the propeller could come off during
operation and be lost.
1)
Apply Yamaha Marine grease or a
corrosion resistant grease to the pro-
peller-shaft.
2)
Install the thrust washer and propeller
on the propeller-shaft.
3)
Install the washer and tighten the pro-
peller nut to the specified torque.
4)
Align the propeller nut with the pro-
peller shaft hole. Insert a new cotter
pin in the hole and bend the cotter pin
ends.
NOTE:
When the propeller nut does not align
with the propeller shaft hole after tighten-
ing to the specified torque, then tighten
the nut further to align it with the hole.
4-17
EMU00977
Removing the Propeller
1)
Straighten the cotter-pin
1
and pull it
out using a pair of pliers.
2)
Remove the propeller nut
2
and
washer
3
.
3)
Remove the propeller
4
and thrust
washer
5
.
E
Tightening torque:
Refer to “SPECIFICATIONS” page 4-1.
602052
000607
r
e
w
q
t
602053
63V-9-16-4 2/18/03 14:56 Page 18
Summary of Contents for 9.9C
