Yamaha 40D, Owner'S Manual

Page: 36 / 77

Operation
31
the boat, sea conditions, and running speed.
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
EMU27881
Adjusting trim angle
Power trim and tilt models
WARNING
EWM00750
●
Be sure all people are clear of the out-
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
●
Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
●
Use the power tilt switch located on the
bottom engine cowling (if equipped)
only when the boat is at a complete
stop with the engine off.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“
” (up).
To lower the bow (trim-in), press the switch
“
” (down).
Make test runs with the trim set to different
angles to find the position that works best for
1. Trim operating angle
ZMU02543
1
1. Power trim and tilt switch
DN
UP
ZMU03835