Operation
24
3.
Place the throttle grip in the “
”
(start) position.
4.
Pull out / turn the choke knob fully. After
the engine starts, replace / return the
knob to the home position.
NOTE:
●
It is not necessary to use the choke when
starting a warm engine.
●
If the choke knob is left in the “
”
(start) position while the engine is running,
the engine will run poorly or stall.
5.
Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
6.
After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
7.
Slowly return the throttle grip to the fully
closed position.
NOTE:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 25.
●
If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
ZMU03744
ZMU02954
ZMU04114
ZMU02030
Summary of Contents for 25D
