Trouble Recovery
65
EMU29462
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse holder and replace the
fuse with a new one of the proper amperage.
WARNING
EWM00630
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
2.
Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
EMU29531
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started with an emer-
gency starter rope.
WARNING
EWM01020
●
Use this procedure only in an emergen-
cy and only to return to port for repairs.
●
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
1. Fuse box
2. Fuse (80 A
×
2, 20 A)
3. Spare fuse (80 A, 20 A)
2
3
1
ZMU05314
1. Manual valve screw
1
ZMU03535
Summary of Contents for 250G
