Yamaha 2016 Grizzly yfm700gplg, Service Manual

Page: 463 / 474

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
10-8
Diagnostic
code No.
Item Display Procedure
01 Throttle angle Check with throttle valve fully
closed.
• Fully closed position 14–20
03 Pressure difference
(atmospheric pressure and
intake air pressure) Displays the intake air pres-
sure. Set the engine stop switch to
“
”, and then operate the
throttle while pushing the
start switch “
”. (If the dis-
play value changes, the per-
formance is OK.)
05 Intake air temperature Displays the intake air tem-
perature. Compare the actually mea-
sured intake air temperature
with the indicated value.
06 Coolant temperature Displays the coolant tem-
perature. Compare the actually mea-
sured coolant temperature
with the indicated value.
07 Vehicle speed pulse 0–999 Check that the number in-
creases when the rear
wheels are rotated.
The number is cumulative
and does not reset each time
the wheel is stopped.
08 Lean angle sensor output
voltage Remove the lean angle sen-
sor and incline it more than
65 degrees.
• Upright 3.6–4.4
• Overturned 0.7–1.3
09 Fuel system voltage
(battery voltage) Approximately 12.0 Turn the main switch to “ ”
(on), and then compare the
actually measured battery
voltage with the display val-
ue. (If the actually measured
battery voltage is low, re-
charge the battery.)
21 Neutral switch Shift the transmission.
• Neutral ON
• In gear OFF
60 EEPROM fault code display The fault code No. 44 detect-
ed EEPROM errors are indi-
cated.
00 indication: Normal status —
61 Malfunction history code dis-
play
• No history 00 —
• History exists Fault codes 12–50
• (If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
—