PERIODIC MAINTENANCE AND ADJUSTMENT
7-11
7
TIP
Skip steps 4–6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the screws.
5. Remove and replace the oil filter
element and O-ring.
6. Install the oil filter element cover by
installing the screws, then tighten-
ing them to the specified torque.
TIP
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11620
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
1. Screw
2. Oil filter element cover
1. Oil filter element
2. O-ring
Tightening torque:
Oil filter element cover screw:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 25 ft·lbf)
Recommended engine oil:
See page 9-1.
Oil quantity:
With oil filter element replacement:
1.60 L (1.69 US qt, 1.41 Imp.qt)
Without oil filter element replace-
ment:
1.40 L (1.48 US qt, 1.23 Imp.qt)
U1BE21E0.book Page 11 Wednesday, May 12, 2010 2:16 PM
