Revision #03
Editware Technical Note
Page 4 of 7
02/07/2003
Fastrack VS and the Yamaha 03D Audio Mixer
Monitoring to amplifier and speakers is from the MONITOR OUT (1/4" TRS) connections
Program Out is from the ST OUT (XLR) connections
Analog inputs 1-8 use balanced XLR connections
Analog inputs 9-16 use 1/4" TRS (tip/ring/sleeve) connections.
Monitor outs uses 1/4" TRS connections.
Bus outs use 1/4" TRS connections.
ST Out uses XLR and is the PROGRAM OUT to any/all record channels.
MONITORING
The 03D has a monitoring bus that can be remotely controlled as a preview bus; therefore, all
audio previews should be done utilizing this preview switcher in the 03D.
Set each source's BUS Out and monitoring in the
[PAN/ROUTE]
section as below for four
channels per source:
The BUS Outputs (1-4) are fed to the RECORD device for recording (or AES Out if the YGADI
option is installed) and the MONITOR OUT connected to amplifier and speakers. The ST OUT
is the signal that is monitored on the MONITOR OUT (when set in
[Bus to ST]
to OFF {not
highlighted}), allowing preview monitoring to be controlled via the 03D mixer. The MONITOR
OUT has a volume control knob for convenient speaker volume adjustment.
