3
Fig.4.2
4. Ball and Valve Seats
4.1
Removal
- Remove the 8 caps (4 caps on the up and down sides
respectively) from the both sides of the upright tie rod.
[Fig.4.1]
- Remove the 4 retainer nuts from the upper side of the upright
tie rods, and then remove the reinforcement plate, out
manifold, and sleeve. [Fig.4.1]
- When you remove the 8 retainer nuts (4 retainer nuts on the
up and down sides respectively) from the both sides of the
upright tie rod, the in manifold is removed from the main
body also. [Fig.4.1]
＜
NOTE
＞
- Since the manifold is designed to be disassembled easily, be
careful to remove it from the main body so that you cannot
happen to drop any of its parts. [Fig.4.2]
- Remove the valve stopper, ball, valve seat and O ring.
[Fig.4.3]
- Turn over the main body assembly. [Fig.4.4]
- Pull out the four upright tie rods, and then remove the base
and in manifold. [Fig.4.4]
Fig.4.3
Fig.4.1
Fig.4.4
