![background image](http://html1.mh-extra.com/html/yamada/afc-9000s/afc-9000s_operation-manual_3106846023.webp)
18
■
If the wasted oil tank is totally full while the machine is operating
1.
Automatic operation of the machine stops temporarily. (The buzzer sounds.)
The wasted oil tank is totally full.
Exhaust the wasted oil.
2.
Take out the wasted oil tank, and remove the wasted oil from the tank with following the procedure for taking
out/setting the wasted oil tank.
(See Section “Taking out/Setting the wasted oil tank” on page 3.)
3.
Set the wasted oil tank.
4. Press the START key.
5.
The machine restarts the operation temporarily stopped.
NOTE
When a new oil pail gets empty or when the wasted oil tank is totally full while the machine is operating, some errors
may be observed in the amount of oil to be replaced due to mixing of air in the oil. Be sure to refill new oil and remove
the wasted oil.
■
If the power cable happens to be disconnected while the machine is operating
1.
Connect the power cable to the AC outlet again.
Press the POWER key to restart the operation.
2.
Press the POWER key, and the START key in this order. The machine restarts the operation.
■
If you want to stop the operation in mid-flow
Hold down the PAUSE/ABORT key for two or more seconds.
The current operation is interrupted. You cannot restart this interrupted operation.
■
To check the total oil already supplied
When you press the SET key while the power is turned off,
you can check the total amount of ATF already supplied.